Versys Seat Riser
As some have noticed, the seat on the Versys is tilted forwards just a little bit too much. There are a few remedies for this, from a new seat cover, to using piles of washers to lift the front end of the stock seat. I have come up with what I think, is a low cost yet elegant solution: A 3D printed Riser Block!
As you can see, it lifts the front of the seat up just a little bit (12mm) to give you a much more comfortable ride. I have about 600+ miles on my riser block and it has been holding up great.
You will need to purchase (2) new 6mm X 40mm bolts from your local hardware store to install this riser.